LITSCO's OmniWall MD panel is an ideal solution for exterior walls or soffits in need of restoration. The stackable panel modules install quickly and hides the fasteners, resulting in a clean, consistent appearance.
This panel is unique in that it is omni directional, allowing it to be installed side-by-side and bottom-to-top, in vertical or horizontal panel orientation.
Vertical or horizontal panel orientation allows this panel to fit to your design requirements. ASTM E330 tested for structural integrity.
Heavier gauge materials result in a stronger panel. Standard panels sizes in both small and large modules.
Can be rear insulated.
All flashing and trim will be fabricated by LITSCO or a qualified fabricator. Flashing shall be .032" -.040" aluminum or 24ga steel.
Streamline Flush TG panels are intended to be installed directly onto 18GA (1/2") or 20GA (7/8") deep galvanized steel subgirts. Maximum subgirt spacing is 30".
#12 pancake Phillips head, self-drilling stainless steel fastener. Fasteners to be installed 12"o.c.
Starting from the bottom, panels are recommended to be installed in a staggered design. Caulk seams with approved urethane or silicone sealant.
• Aluminum, .040" / .050", Finish per specification
• Copper, 16oz / 20oz Cold Rolled, Lead Coated or Freedom Gray